| Post Name | JUNIOR INSTRUCTOR (DRAFTSMAN CIVIL) / ENGINEERING ASSISTANT GR.II (SR AMONG ST ONLY) - INDUSTRIAL TRAINING / KERALA STATE CONSTRUCTION CORPORATION LTD |
|---|---|
| Question Paper Code | 070/2019 |
| Date of Test | 12 December 2019 |
| Medium of Question | ENGLISH |
| Exam Type | OMR Examination |
| Total Questions | 100 |
1
IS 10714 : 2001 refers to :
Answer
B. lines
2
A2 size sheet has the dimensions :
Answer
C. 594 mm ο΄ 420 mm
3
Which one of the following is not a reduction scale?
Answer
C. 1:1
4
The preferred line width for letter group of 7 mm is :
Answer
Question Cancelled
5
The symbol ' S ο¦ ' indicates :
Answer
B. spherical diameter
6
A diagonal scale of RF 10 is constructed to measure maximum distance of 10 mm. The LC of
this scale would be :
Answer
A. 0.01 mm
7
Which one of the following is an input device?
Answer
A. Mouse
8
The most effective command used to draw symmetrical objects is :
Answer
D. MIRROR
A 3
9
The command used to erase the object partly is :
Answer
C. TRIM
10
Which one of the following is not a toolbar in AutoCAD?
Answer
C. Standard
11
A scale that is used to represent three units of measurements, such as meters, decimeters
and centimeters is called :
Answer
D. Diagonal scale
12
In drawing, letters and numbers are designated by their :
Answer
B. height
13
In third angle projection top view is drawn :
Answer
A. above XY line
14
The most common input device used today is the :
Answer
B. Key board
15
A line is placed in the first quadrant in such a way that the line is inclined to HP and parallel
to VP. The elevation will be lies in :
Answer
A. VP
16
Combining two or more plots as a single plot is called :
Answer
D. Amalgamation
17
Which is not a type of building?
Answer
D. Domestic building
70/2019 4 A
18
The LEED system rates buildings platinum on the basis of :
Answer
Question Cancelled
19
Head room in a staircase should not be less than :
Answer
D. 2.1 m
20
On the basis of fire resistance, National Building Code of India, a building with fire
resistance more than 4 hours is classified as :
Answer
A. Type 1
21
From the consideration of earthquake resistance the plan of a building preferred is :
Answer
A. square
22
The building plan is a section at the level :
Answer
D. sill
23
Key plans are drawn :
Answer
A. not to scale
24
The built up covered area of a building measured at the floor level of any storey :
Answer
C. plinth area
25
The most suitable flooring for dance hall is :
Answer
C. Wooden flooring
26
The headquarters of Survey of India is located at :
Answer
D. Dehradun
A 5 70/2019
27
The line to be measured accurately in a chain survey is
Answer
B. base line
28
For hilly region the ideal method of contouring is :
Answer
D. radial line method
29
Magnetic meridian and true meridian are :
Answer
D. never parallel
30
Which unit in total station processes data collected?
Answer
D. microprocessor
31
GIS deals with which kind of data :
Answer
C. spatial data
32
TIN stands are :
Answer
B. Triangulated Irregular Network
33
The contours which are parallel and equidistant on an area, then that area should be :
Answer
D. uniform slope
34
The method of orienting a plane table with two inaccessible points is known as :
Answer
Question Cancelled
35
Size of a theodolite is specified by :
Answer
A. The diameter of lower plate
36
In levelling a station is a point where :
Answer
A. staff is placed
37
A plane surface on a contour map is indicated by:
Answer
C. Series of straight, parallel and equal spaced contours
38
The rocks having clay as their major constituent are known as:
Answer
B. Argillaceous rocks
39
Most whether resisting metamorphic rock is:
Answer
D. Quartzite
40
The minimum water cement ratio required for making concrete:
Answer
A. 0.4
41
Product of blast furnace is known as :
Answer
B. Pig iron
42
Due to attack of dry rot, the timber :
Answer
Question Cancelled
43
The maximum size of the aggregate used in a damp proof course is about :
Answer
B. 10 mm
44
The window provided on the sloping roof of a building is called as :
Answer
A. Dormer window
45
The roof having slope in all four directions is called :
Answer
A. Hip-pitch roof
46
A step approximately triangular in shape is known as :
Answer
Question Cancelled
47
In a three coat plastering, the third coat known as :
Answer
B. Setting coat
48
Type of pointing in which V shaped projection is provided outside the wall surface is called :
Answer
Question Cancelled
49
The amount of gypsum, usually added in manufacture of cement is :
Answer
C. 1 to 3%
50
Modulus of rigidity may be defined as the ratio of :
Answer
D. shear stress to shear strain
51
The moment of inertia of an area is always least with respect to :
Answer
B. central axis
52
If a stable simply supported beam have roller support at one end, then the other end will be :
Answer
B. hinged
53
The bending moment diagram for a cantilever carrying uniformly distributed load will be :
Answer
C. a parabola
54
The product EI is also known as :
Answer
A. Flexural rigidity
55
The beam section has to be redesigned if the shear stress exceeds the allowable shear stress
by :
Answer
B. 4 times
56
A simply supported beam is considered as a deep beam if the ratio of effective span to overall
depth is less than :
Answer
B. 2
57
The maximum strain in concrete at the outer most fibre is :
Answer
C. 0.0035
58
The anchorage value of 90ο° hook is :
Answer
D. 8ο¦
59
Shear taken by bent up bars is limited to :
Answer
C. Vs 2
60
Which one of the following is the mode of failure in fillet weld material?
Answer
B. Shear
61
Maximum spacing of vertical stiffeners in plate girder is :
Answer
C. 1.5 d
62
For welding, the partial safety factor for site welding is taken as :
Answer
C. 1.5
63
When the bolts are staggered at equal intervals and gauge does not exceed?
Answer
B. 75 mm
64
The upper yield point in the stress-strain curve in structural steel can be avoided by :
Answer
B. hot working
65
In measuring form work no deduction is made for opening:
Answer
C. 0.4 m2
66
Original cost of property minus depreciation is:
Answer
A. book value
67
The volume is measured correct to the nearest:
Answer
A. 0.01 cum
68
The expected out turn for earth work in excavation in ordinary soil per mazdoor per day is:
Answer
C. 3.00 cum
69
The ratio of cost of labour to the total cost of the building is:
Answer
B. 1:4
70
A work costing less than Rs. 20,000 is termed as:
Answer
A. petty work
71
Which one is overhead expenditure of the following items?
Answer
Question Cancelled
72
The estimated quantity of cement required in cement mortar (1:6) per cubic meter will be :
Answer
A. 5.6 bags
73
The fresh detailed estimate of the additional work in addition to the original one is called :
Answer
C. supplementary estimate
74
The area of cross section of trapezoidal section is of formation width βBβ, central depth βdβ and
side slope βSβ is:
Answer
A. Bd ο« Sd 2
75
For computing the quantity of earth work using prismoidal formula the number of required
sectional area will be:
Answer
C. odd
76
Length of common rafter in a tiled roofing, when the rise of roof is 1/3 span is:
Answer
D. 0.60 eave span
77
Which one of the following is not surface water?
Answer
B. from natural spring
78
Maximum permissible colour of water for domestic supply on cobalt scale is:
Answer
B. 10 to 20 ppm
79
Floatation is a method of water purification by:
Answer
C. solid transfer
80
Process of killing pathogenic bacteria from water is known as:
Answer
D. disinfection
81
In treating swimming pool, water the filtration system to be used is:
Answer
C. pressure filters
82
Water from kitchen, bathrooms and washbasin is called:
Answer
A. sullage
83
Which soil can take maximum dose of sewage?
Answer
D. Sandy soil
84
In an office building one water closet should be provided for every ββββββββββ number of
male personnel.
Answer
D. 25
85
Bacteria that survive in the absence of oxygen are known as :
Answer
B. anaerobic bacteria
86
In case of public water supplies, the permissible upper limit of chloride content is:
Answer
D. 250 ppm
70/2019 12 A
87
The colour of fresh sewage is:
Answer
C. grey
88
The minimum depth of water seal in a good trap is:
Answer
A. 2.5 to 7.5 cm
89
The total depth of water required by a crop during the entire period the crop is in the field, is
known as:
Answer
B. delta
90
Among the following, which crop has the highest value to delta?
Answer
C. rice
91
Irrigation canals are generally aligned along:
Answer
B. water shed
92
The standard height of a standard rain gauge is:
Answer
Question Cancelled
93
The best irrigation method that suits area where scarcity of irrigation water is:
Answer
C. drip irrigation
94
Which of the following is not a Rabi crop?
Answer
B. Ground nut
95
The road connecting a district headquarters of one state to the district headquarters of a
neighboring state is called:
Answer
B. National highway
96
Warning signs are shown on a rectangular board of size:
Answer
Question Cancelled
97
The headquarter of the Indian Road Congress is at:
Answer
D. New Delhi
98
Mandatory signs are displayed on a disc having a diameter:
Answer
D. 60 cm
99
Regulatory signs are shown at a height of ββββββββββ from road surface.
Answer
B. 2.0 m
100
Which one of the following is not an informatory sign?
Answer
Question Cancelled
Discussion
Ask a doubt or share a tip.
No comments yet β start the discussion.