| Post Name | Tractor Driver - Department Ground Water |
|---|---|
| Question Paper Code | 097/2023/OL |
| Category Code | 395/2020, 405/2020, 406/2020 |
| Date of Test | 27 June 2023 |
| Exam Type | Online Examination |
| Total Questions | 100 |
1
Currency of a learners licence is __________
Answer
C. 6 months
2
Which of the following is not a transport vehicle?
Answer
D. Motor Car
3
Minimum age to obtain a learners licence for motor cars is
Answer
B. 18 years
4
Minimum learning period to attend practical test on driving is
Answer
A. 30 days
5
The colour of the registration number plate in Battery operated Electric Motor car
Answer
B. White colour on green background
6
Time limit prescribed in M.V. Act, to apply for transferring an insurance Certiļ¬cate, from the date of transfer is
Answer
A. 14 days
7
Maximum gross vehicle weight of a light motor vehicle is
Answer
D. 7500 kg
8
Maximum validity of Goods Carriage Permit is
Answer
C. 5 year
9
Registration validity of a Motor Car is
Answer
B. 15 years
10
Pollution under control certiļ¬cate is compulsory for all vehicles, after completion of ______ period from the date of registration.
Answer
A. One year
11
Maximum speed limit of a Heavy Goods Vehicle at school zone is
Answer
D. 30 km/hr
12
A vehicle shall not be parked
Answer
B. On a footpath, Cycle Track, Pedestrian crossing
13
The passenger capacity of a Tractor other than driver is
Answer
A. No person
14
Maximum speed while towing a vehicle shall not exceed ____________ km/hr.
Answer
C. 25
15
Distance to be maintained with a vehicle moving in front of our vehicle is
Answer
D. None of these
16
A red coloured octagon is sign for
Answer
A. To stop
17
On mountain roads and steep roads priority is for ________
Answer
C. Vehicles going uphill
18
________ indicates to slow down and proceed with caution.
Answer
B. Flashing amber
19
The driver shall switch on the _________ before entering a tunnel.
Answer
D. Dipped lights
20
The driver of a non-transport vehicle shall always carry with him in physical or electronic form
Answer
D. All of the above
21
Broken white lines along the centre of the road means
Answer
B. Over taking is allowed
22
Continuous yellow line along the centre of the road is
Answer
D. All of these
23
Most dangerous line is
Answer
C. Yellow line
24
Zebra-crossing is a
Answer
A. Transverse marking
25
White line along the side of the road is known as
Answer
C. End of carriage way
26
Yellow line along the side of the road for
Answer
A. No parking
27
Which of the following statement is/are correct about ladder hatchings? (i) Marking at the centre of the road in the shape of a ladder (ii) Used as divider in dangerous areas (iii) Over taking is prohibitted
Answer
D. All of the above (i), (ii) and (iii)
28
On yellow box marking
Answer
D. All of these
29
Diagonal marking on the road is for indicating?
Answer
A. Median
30
Zig-zag road markings (i) School/hospital zone (ii) Careful for side entering (iii) Follow speed limits
Answer
D. All statement are correct (i), (ii) and (iii)
31
Traļ¬c signs are mentioned in which schedule of the motor vehicle Act?
Answer
A. First Schedule
32
How many types of traļ¬c signs are mentioned in Motor Vehicle Act?
Answer
B. 3
33
Which is the signal operated by Land only?
Answer
C. Overtaking
34
Shape of cautionary sign is
Answer
D. Triangle
35
Give-way sign is R ___________ sign?
Answer
B. Mandatory
36
Design of stop sign is?
Answer
D. Octagon
37
Informatory sign is
Answer
C. Hospital
38
T-junction, Y-junction, X-junction comes under
Answer
A. Cautionary signs
39
Which is a mandatory sign?
Answer
C. Speed limit
40
Violation of mandatory sign is
Answer
A. Punishable
41
A pressure cap is used instead of a normal cap in radiator to attain: (i) To increase system pressure (ii) To hold the cap tight (iii) To increase boiling point of Coolant. (iv) To maintain the system leak proof
Answer
D. (i) and (iii) are correct
42
Tractor is a vehicle
Answer
B. Designed to deliver High tractive eļ¬ort at low speed
43
Psi in tyre pressure means
Answer
C. Pounds per Square Inch
44
Advantages of Disc Plough are: (i) Useful on hard surfaces with rocks (ii) It cuts, lifts and inverts the soil (iii) Covers the area in a faster speed (iv) Digs Deeper
Answer
B. (i), (ii) and (iii) are true
45
Which part in a single point Hitch takes care of variations in ļ¬eld condition?
Answer
D. Swinging draw bar
46
Which of the following are good characteristics of brake ļ¬uid? (i) Anti Corrosive (ii) Evaporative
Answer
A. Only (i) is correct
47
What will happen if an engine run without Air ļ¬lter/Cleaner?
Answer
C. Faster wear of engine moving parts
48
Coolant is to be replaced-
Answer
B. As per manufacturer's speciļ¬cation
49
The Unit supplies rotary power to stationary machines from a tractor is-
Answer
A. PTO
50
Rota Tiller is being driven by _____________ in a Power Tiller.
Answer
C. Chain
51
For cutting thin tubing, the most suitable pitch of the hacksaw blade is?
Answer
D. 0.8 mm
52
The cutting angle for chipping iron is?
Answer
A. 60Ā°
53
Proper leverage is provided to the engine output to pull the vehicle load by ___________
Answer
D. Gear box
54
Components of clutch disc which absorbs frictional vibrations during torque triangular?
Answer
Question Cancelled
55
The pressure o ļ¬uid in hydraulic brake system is governed by?
Answer
C. Pascals law
56
Axle half shaft is splinted into
Answer
A. Sun gear
57
The starter armature rotates due to magnetic pole
Answer
C. Attraction and repulsion
58
The current regulator winding is connected with dynamo's armature
Answer
B. In series circuit
59
The high fuel consumption of a petrol engine may be due to
Answer
A. Leakage of fuel from carburetor
60
Adjusting screw for adjusting air pressure in tank is provided
Answer
C. Unloader valve
61
The ļ¬uid pressure in master cylinder depends on
Answer
A. Master cylinder piston area
62
The step bore wheel cylinder, uses two rubber cups of
Answer
B. One cup is larger dia and another is smaller meters
63
The angle between centre line of king pin and a vertical line from centre point of tyre is called
Answer
D. Kingpin inclination
64
In which type of steering gear box variable steering ratio is achieved?
Answer
D. Rack and pinion steering gear
65
Complete vehicle without body is called as
Answer
A. Chassis
66
Air bleeding is done in hydraulic brake is to?
Answer
C. Remove air in the system
67
CRDI stands for _________
Answer
B. Common rail direct injection
68
Suspension component which control the vibration of suspension springs
Answer
A. Shock absorbs
69
Turbo charge is equipped for _________
Answer
B. Increase volumetric eļ¬ciency
70
Reduction catalyst used in a catalytic convertor is
Answer
B. Rhodium
71
In a hydraulic brake system the ļ¬uid pressure is converted to mechanical movement by
Answer
D. Wheel cylinder
72
Which is the important part for locking the hitch pin?
Answer
B. Linch pin
73
In disc harrow the function of scraper is to?
Answer
A. remove the sticked soil from disc
74
Which part of the farm tractor takes care wide range of variation in the ļ¬eld condition?
Answer
D. Swinging draw bar
75
Which materials used to make micrometer anvil?
Answer
A. Carbide
76
Who is the issuing Authority of driving licence in Kerala?
Answer
A. Motor Vehicles department
77
Which of the following tool is used to remove a broken stud?
Answer
C. Screw extractor
78
Which of the following tool is very necessary for engine assembling?
Answer
D. All of the above
79
In the following what instrument is used to measure the current ļ¬ow from battery and viceversa?
Answer
C. Ammeter
80
Which of the following instrument is used in a vehicle to measure the travelled distance?
Answer
C. Odometer
81
What is the expansion of "SMF" battery?
Answer
A. Sealed Maintenance free
82
In the following Jacks what type is commonly used for cars?
Answer
B. Scissor jacks
83
What is the function of Air cleaner in a vehicle?
Answer
D. All of the above
84
What pollutant contained in the exhaust gas is mostly not harmful for human?
Answer
B. Carbon dioxide
85
Which of the following part is not an internal part of engine?
Answer
B. Flywheel
86
Premium type gasoline fuel having
Answer
B. Octare number - 93
87
CRDI stands for
Answer
C. Common Rail Diesel Injection
88
Which of the following is not a reason for high oil pressure of engine?
Answer
A. Excessive wear of engine parts
89
Which one of the following is the best spark plug for the engine?
Answer
A. Iridium
90
Which of the following is not included in the Unsprung weight of a Vehicle?
Answer
D. Diļ¬erential
91
An over inļ¬ated tyre will wear the tread most near the
Answer
A. Center
92
Braking is produced by the frictional eļ¬ect between the breake drum and
Answer
B. Brake linings
93
Front wheel alignment is adjusted by altering
Answer
B. Length of track road
94
Which transmission unit disengages the drive and provides a smooth take up of the drive?
Answer
D. Clutch
95
The output of an alternator is controlled by
Answer
A. Voltage regulator
96
Crash sensors are located
Answer
C. Behind the front bumper
97
In an EFI system which of the following statement is true?
Answer
D. All of the above
98
What is the function of DTC?
Answer
B. It diagnose engine malfunctions
99
________ prevents someone from starting the engine with an incorrectly coded key.
Answer
C. Engine immobilizer
100
Which sensor measures the presence of oxygen in the exhaust system of a car?
Answer
A. O2 Sensor
Discussion
Ask a doubt or share a tip.
No comments yet ā start the discussion.